Bosch Serie 6 WGA254U0AU manual
7.5 · 1
View the manual for the Bosch Serie 6 WGA254U0AU here, for free. This manual comes under the category washing machines and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Bosch Serie 6 WGA254U0AU or do you need help? Ask your question here
- en Instruction Manual and Installation Instructions
- Display rules
- : Warning!
- Caution!
- Note/tip
- 1. 2. 3. / a) b) c)
- Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 4
- ( Safety instructions 5
- 7 Environmental protection 11
- 5 Positioning and connecting 12
- * Getting to know the appliance 21
- Z Laundry 24
- C Detergent 25
- P Overview of programmes 27
- 0 Programme default settings 30
- \ Additional programme settings 31
- 1 Operating the appliance 32
- Q Appliance settings 36
- H Sensors 36
- 2 Cleaning and maintenance 37
- 3 Faults and what to do about them 41
- 4 After-sales service 46
- [ Consumption values table 47
- J Technical information 48
- r Aqua-Stop warranty 50
- 8 Intended use
- Intended use
- ( Safety instructions
- Safety instructions
- Children/people/pets
- Installation
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of fire/material damage/ damage to the appliance!
- : Warning
- Risk of injury/material damage/damage to the appliance!
- : Warning
- Risk of injury!
- Caution!
- : Warning
- Operation
- Cleaning/Maintenance
- Safety instructions
- 7 Environmental protection
- 5 Positioning and connecting
- 2. Unscrew and remove all four transport brace screws.
- 3. Fit the covers.
- 4. Lock the covers firmly in place by applying pressure to the snap-in hooks.
- 2. Remove the transport struts.
- 3. Undo and remove the screws on the horizontal transport strut.
- 4. Remove the transport strut.
- 2. Open the water tap carefully, checking the leak tightness of the connection points. The screw connection is under mains water pressure.
- Note:
- Alignment
- 2. Check the alignment of the appliance with a spirit level, and adjust it if necessary. Change the height by turning the appliance feet.
- 3. Tighten the lock nut against the housing.
- 2. Turn the water tap on.
- 3. Close the door. Do not load any laundry.
- 4. Run two cycles of Cottons i 90 °C programme.
- 5. Open the detergent drawer.
- 6. Pour approx. 1 litre of water into dispenser II.
- 7. Add standard detergent to dispenser II according to manufacturer’s instructions for light soiling.
- Note:
- 8. Close the detergent drawer.
- 9. Select Start/Reload A.
- 10. When the programme ends, turn the programme selector to Off.
- 2. Reduce the water pressure in the supply hose. ~ Page 40
- 3. Drain any residual water. ~ Page 39
- 4. Disconnect the appliance from the mains.
- 5. Remove the hoses.
- 6. Empty the dispensers.
- 8. Close the detergent drawer.
- Note:
- Intended use
- 8 Intended use 4
- * Getting to know the appliance
- Getting to know the appliance
- Appliance
- Control panel
- Display panel
- Programme default settings
- Additional programme settings
- Status indicators for the programme progress (programme sequence)
- Display
- Setting
- Z Laundry
- Note:
- Starching
- 2. Select the à Rinse programme.
- 3. Measure starch into dispenser I in accordance with the manufacturer's instructions (clean first if necessary).
- 4. Touch the Start/Reload A button.
- 2. Select the ñ Finished in button repeatedly until the required number of hours is displayed.
- 3. Select the Start/Reload A button.
- 2. Select the ñ Finished in button repeatedly to change the number of hours.
- 3. Select the Start/Reload A button.
- Display
- Select a programme with a stain type:
- 1. Arrange items of washing as usual.
- 2. Select a programme.
- 3. Select a stain type (depending on the selected programme).
- 4. Start the programme.
- 2. Turn the water tap on.
- 3. Open the appliance door.
- 2. Pour in detergent and/or cleaning product.
- 2. Pour liquid detergent into liquid detergent container and do not exceed the Maximum mark.
- 3. Close the detergent drawer.
- 2. Select another programme.
- 3. And touch the Start/Reload A button again. The new programme starts from the beginning.
- 2. To cool down laundry: Select à Rinse.
- 3. And touch the Start/Reload A button again.
- 2. Select 0 [ Spin/Drain.
- 3. And touch the Start/Reload A button again.
- 2. Open the door and remove the laundry.
- 3. Turn off the water tap.
- Note:
- 1. Arrange items of washing as usual.
- Activate setting mode:
- Changing the volume and drum care information
- H Sensors
- 2 Cleaning and maintenance
- 2. To remove the insert: Push the insert upwards from below with your finger.
- 3. Clean the detergent dispenser tray and insert with water and a brush, and dry it. Clean the inside of the housing as well.
- 4. Fit the insert and lock it in place (push the cylinder onto the guide pin).
- 5. Push in the detergent drawer.
- 2. Clean the measuring aid and cover with water and brush.
- 3. Install the cover back to the measuring aid. Pay attention to the assemble mark, and press the cover until click sounds.
- Note:
- Drain pump is blocked
- 2. Open the service flap.
- 3. Take the drain hose out of the retainer.
- 4. Carefully unscrew the pump cover; residual water may leak out.
- 5. Refit and screw on the pump cover. The handle must be in a vertical position.
- 6. Close the service flap.
- 2. Loosen the hose clamp. Carefully remove the drain hose; residual water may leak out.
- 3. Clean the drain hose and siphon connecting piece.
- 4. Re-attach the drain hose and secure the connection point using the hose clamp.
- 2. Select the Cottons i (activate G SpeedPerfect setting) programme.
- Note:
- 3. Select the Start/Reload A button. Allow the programme to run for approx. 40 seconds.
- 4. Turn the programme selector to Off.
- 5. Pull out the mains plug.
- 2. Use pliers to remove the filter.
- 3. Clean the filter with a small brush.
- 4. Connect the hose and check for leaks.
- 2. Open the service flap.
- 3. Drain the water. ~ Page 39
- 4. Pull the emergency release downwards with a tool and release.
- 3. Select the Start/Reload A button. Allow the programme to run for approx. 40 seconds.
- Getting to know the appliance
- [ Consumption values table
- Supplementary sheet for the installation and operating instructions
- Energy and water consumption, programme duration and residual moisture for the main washing programme (approximate values)
- 2. The liability guarantee is valid for the service life of the appliance.
- 3. It is a prerequisite of all warranty claims that the appliance with Aqua- Stop must have been installed and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (genuine accessories).
- 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.
- Supplementary sheet for the installation and operating instructions
General
| Bosch | |
| Serie 6 WGA254U0AU | |
| washing machine | |
| English | |
| User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch Serie 6 WGA254U0AU below.
Is the manual of the Bosch Serie 6 WGA254U0AU available in English?
Yes, the manual of the Bosch Serie 6 WGA254U0AU is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Bosch and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Bosch owners to provide you with a good answer.
Where to put powder washing detergent
I have child lock activated? Key sign? Showing 1.00 ?
Machine locked on rinse cycle …… tried what manual describes nothing works
How do you set a 30 min wash. It won’t start after I’ve selected this option.
I have problem with my Boch drying machine it keeps beeping three sec and it shows keys how to reset it ,to keep going again please.
How do I clean out the filter
How can I remove the detergent dispenser drawer handle in order to replace a damaged detergent drawer?
i need an english manual for Bosch wash and dry serie 6 WDU8H501FF
Are you able to make your 10kg machine have more water when your washing and rinsing ? If so where does it show you in the manual. ? Kind Regards Denis.
how do I remove the filter?
Number of questions: 13