View the manual for the Junkers WR 11-2 B here, for free. This manual comes under the category water heaters & boilers and has been rated by 289 people with an average of a 8.3. This manual is available in the following languages: English. Do you have a question about the Junkers WR 11-2 B or do you need help? Ask your question here


| Brand | Junkers |
| Model | WR 11-2 B | 7701331627 |
| Product | water heater & boiler |
| EAN | 4047416115351 |
| Language | English |
| Filetype | User manual (PDF) |
| Type | Tankless (instantaneous) |
| Boiler system | Solo boiler system |
| Heater location | Indoor |
| Placement supported | Vertical |
| Product colour | White |
| Gas exhaust diameter | 110 mm |
| Solar batteries support | Yes |
| International Protection (IP) code | IPX4D |
| Fuel type | Methane |
| Boiler type (NL label) | - |
| Input connection type | G 1/2 |
| Domestic Hot Water (DHW) flow | 11 l/min |
| Minimum power | 7000 W |
| Maximum power | 19200 W |
| Minimum operating pressure | 0.1 bar |
| Maximum operating pressure | - bar |
| Adjustable thermostat | Yes |
| Width | 310 mm |
| Depth | 220 mm |
| Height | 580 mm |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Junkers WR 11-2 B below.
Yes, the manual of the Junkers WR 11-2 B is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Junkers and is the answer not in the manual?
Question and answer
Number of questions: 7Good afternoon, I have a Junkers that turns off when we turn on the hot water and shows F7 on the display. Can someone help me?
This message has been automatically translatedHow to know if the boiler pressure is 0 and how to increase it or how is it done? Thank you.
Hello, we have installed new batteries, a new gas cylinder and when opening the faucet, the water heater does not work and the water comes out cold, what could be the problem???
The water heater turns on, flashes on 17/18, the red light turns on and the code EA appears. No hot water comes out. Can you help?
I have a gas water heater WR14-2B. Every time I take a shower, it turns off, it doesn't last more than two minutes, I have to close the mixer and reopen it. Can you kindly tell me the cause? Thank you.
This message has been automatically translatedWear are the batteries housed on the boiler.
1 comment
@Tony batteries are housed in small grey plastic box below on/off switch. Push the two side clips inwards to open the box.
I replaced the batteries but still no response, can I use manual lighter?