FOR SERVICE TECHNICIAN’S USE ONLY 1
W11416395A
IMPORTANT SAFETY NOTICE — “For Technicians only” This service data sheet is intended for use by persons having electrical, electronic, and mechanical experience and
knowledge at a level generally considered acceptable in the appliance repair trade. Any attempt to repair a major
appliance may result in personal injury and proper ty damage. The manufacturer or seller cannot be responsible, nor
assume any liability for injury or damage of any kind arising from the use of this data sheet.
IMPORTANT: Electrostatic Discharge (ESD) Sensitive Electronics ESD problems are present everywhere. Most people begin to feel an ESD discharge at approximately 3000 V . It takes as
little as 10 V to destroy , damage, or weaken the main control assembly . The new main control assembly may appear to
work well after repair is finished, but a malfunction may occur at a later date due to ESD stress.
Ƀ
Use an anti-static wrist strap. Connect wrist strap to green earth connection point or unpainted metal in the
appliance.
– OR –
T ouch your finger repeatedly to a green ground connection point or unpainted metal in the appliance.
Ƀ
Before removing the part from its package, touch the anti-static bag to a green ground connection point or unpainted
metal in the appliance.
Ƀ
Avoid touching electronic parts or terminal contacts; handle electronic control assembly by edges only .
Ƀ
When repackaging main control assembly in anti-static bag, observe above instructions.
Voltage Measurement Safety Information When performing live voltage measurements, you must do the following:
Ƀ
V erif y the controls are in the off position so that the appliance does not star t when energized.
Ƀ
Allow enough space to per for m the voltage measurements without obstr uctions.
Ƀ
Keep other people a safe distance away from the appliance to prevent potential injury .
Ƀ
Always use the proper testing equipment.
Ƀ
Af ter voltage measurements, always disconnect power before ser vicing.
DANGER Only authorized technician s should
perform diagnostic voltag e measurements.
After performing voltag e measurements ,
disconnect power before serv icing.
Failure to follow thes e instructions ca n
result in death or electrical shock.
Need help?
Do you have a question about the Maytag and is the answer not in the manual?
Question and answer
Number of questions: 2If the washer load is not level, how can I shift the load without starting the cycle all over again? Model MVW6200KW1.
How do you use the bleach dispenser?
This message has been automatically translated